Powder Vacuum Conveying Machine

The powder vacuum conveying machine is primarily used to transport powdery and granular materials, such as active pharmaceutical ingredient powders, chemical powders, metal oxide powders, explosive powders, capsules, tablets, pills, small food granules, and explosive granules. It is not suitable for materials that are overly wet, sticky, or excessively heavy.

Request Information & Get a Quote

Product Introduction

Operating Steps of the Powder Vacuum Conveying Machine

1. Equipment Inspection
Before using the vacuum conveying machine, users must inspect the equipment to ensure it is functioning properly. Many production issues arise because the equipment is not checked prior to use, leading to disrupted material flow and unnecessary material waste. Therefore, inspection is a critical first step.

2. Starting the Equipment
When starting the vacuum conveying machine, operations should commence promptly. Delaying material loading after the machine has been running can cause idle operation, reducing performance and shortening equipment lifespan. Users should start loading materials immediately after powering on the machine to ensure proper operation.

3. Operating Process
During material loading, attention to technique and operational details is essential to avoid issues. Improper handling can prevent the machine from functioning correctly, affecting production quality and efficiency. Users are reminded to follow operational procedures carefully to ensure smooth and accurate conveying.

4. Shutting Down the Equipment
After material loading is complete, the machine should be turned off promptly to save energy. Leaving the machine running idle can significantly impact its performance and longevity.

Although these steps may appear simple, many operators fail to standardize procedures in practice. Proper attention to operational details is crucial to maintain consistent production performance.

Maintenance of the Powder Vacuum Conveying Machine

1.Filter Maintenance

Instructions: Regularly inspect the filter surface and check the tightness of nuts to prevent clogging, damage, or detachment.

Method: Use compressed air to clean accumulated dust from the filter surface; water may also be used if necessary.

Frequency: For new machines, inspect weekly; thereafter, adjust based on usage.

2.Water-Circulating Vacuum Pump Maintenance

Instructions: Regularly check the turbidity of water in the tank. When starting the vacuum conveying machine, observe whether material is present at the drainage outlet.

Method: Replace the tank water if it becomes excessively dirty.

Frequency: Weekly is recommended, depending on water quality.

3.Electrical Maintenance

Instructions: Because pneumatic control is involved, ensure compressed air is free of water, oil, and impurities to prevent damage to electrical components.

Method: Use a three-stage filter system; for special cases, add two additional filters.

Frequency: Drain water or oil accumulations promptly as needed.